Graphite Design Tour AD TP-6 S Mini Driver 3W etc.
Graphite Design TP6
This is a custom-made shaft for Callaway.
The manufacturer's hologram is still attached.
It was originally on a driver, but it appears the butt end has been cut by about 1 inch.
The tip end is likely uncut.
Flex: S
Length: Approximately 42.375 (42 3/8) inches
Tip Preparation: 1.375 (1 3/8) inches
There is some paint chipping about 3.5cm from the tip, but it is in an area that will be covered by the ferrule, so it should not be an issue.
This shaft can be used for short drivers (around 44.25 inches for Callaway), mini drivers, 3-woods, etc.
Please feel free to contact us if you have any questions. m(_ _)m
This is a custom-made shaft for Callaway.
The manufacturer's hologram is still attached.
It was originally on a driver, but it appears the butt end has been cut by about 1 inch.
The tip end is likely uncut.
Flex: S
Length: Approximately 42.375 (42 3/8) inches
Tip Preparation: 1.375 (1 3/8) inches
There is some paint chipping about 3.5cm from the tip, but it is in an area that will be covered by the ferrule, so it should not be an issue.
This shaft can be used for short drivers (around 44.25 inches for Callaway), mini drivers, 3-woods, etc.
Please feel free to contact us if you have any questions. m(_ _)m
Category
Club
Brand
GRAPHITE DESIGN
Condition
Some scratches/marks
Shipping
Included in price (by seller)
From
Miyazaki
Customers Also Viewed
Was this page helpful?
marty.unleash.wiring disabled
