Climbing Holds Set of 9 (Fat Round)

【Overview】
These are screw-on holds made with a 3D printer.
This is a set of 9 holds in total: 3 large, 4 small, and 2 feet.
You can specify the color.
Examples include black, white, red, blue, yellow, etc.

Friction Processed
The friction is applied in a triangular pattern, allowing you to enjoy a unique and ever-changing grip feel. Additionally, the unprocessed areas also have a matte friction, so they are not slippery like typical dual-texture holds.

【Introduction to Each Hold】
The feet are quite challenging, but they are designed to be less likely to slip out than they appear due to the friction on the entire surface (Image 4).
The small holds are useful for creating dynamic routes with positive crimps (Images 5, 6).
The two types of large holds are positive holds that can be gripped in a pinch (Images 7, 8). They can be enjoyed in a vertical or undercling position.
The largest hold is a sloper crimp that slightly restricts movement, making it the crux of the route (Image 9).

【Important Notes】
Climbing holds made with 3D printers are durable due to their hardness and light weight.
They will soften at temperatures above 100°C (212°F).
While they should be fine for normal use, please be cautious in environments like the inside of a car during summer.
Also, overtightening with an impact driver can weaken the area around the screw hole due to friction heat. Please avoid excessive tightening.

Made of PLA
Recommended Angle: 90° - 120°

Bouldering, Climbing, Training, Grip Training, Crimp Training, Holds