PekeB Exclusive: Spacia Custom MK53s Camber Plates

These are camber plates that were used on an MK53S Spacia Custom.

They were used for about 3 months, but since the plates were purchased used, there is some rust.

●Product Specifications●
Rear Camber Angle: 5.0 degrees

Achieve stable camber settings with gradient processing.
Minimizes offset changes with the minimum necessary thickness.
Toe adjustable design. Toe is corrected by changing the plate thickness. Achieve proper toe by combining different thicknesses.
Installation is limited to vehicles with ABS.

This is a competition part. The image is for illustration purposes, and the appearance may vary depending on the setup.

Depending on the vehicle height, toe may not be fully adjustable, so please adjust with commercially available washers, etc.
If changing to long bolts, low-profile cap bolts with dimensions of approximately M10 pitch 1.25 and length 30mm are recommended.

*Depending on the vehicle height, the toe angle may be compromised. Individual vehicle variations may occur, and the camber angle may differ from the specifications. Limited to vehicles with ABS.

Important Information
This product is not compatible with vehicle inspections. It is not designed for use on public roads as it does not maintain the same strength as genuine parts. This is a competition part designed for display vehicles at event venues. We are not responsible for any accidents, failures, damages, or breakage during installation or use. All use is at your own risk.

Thank you for viewing.